Owner Manual

25
Step 10: Swing Wall Assembly
Part 1
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws.
Note: Keep all bolts loose in this step.
A: On the ground lay at 2 (1931) Posts then attach (1933) Ground SW with 4 (H2) 1/4 x 2” Hex Bolts (with
lock washer, at washer and t-nut); and (1895) Floor End using 2 (H2) 1/4 x 2” Hex Bolts (with lock washer, at
washer and t-nut) in the bottom holes as shown in g. 10.1.
B: On the side indicated in g. 10.1, attach (0369) Lower Diagonal to (1933) Ground SW with 1 (H2) 1/4 x 2”
Hex Bolt (with lock washer, at washer and t-nut).
C: Make sure assembly is square and then fasten (1895) Floor End to (1931) Posts in the top holes using 2
(LS1) 1/4 x 1-1/2” Lag Screws (with at washer); and (0369) Lower Diagonal to (1931) Post with 1 (LS3) 1/4 x 3”
Lag Screw (with at washer). (g. 10.2)
Notice the hole
locations of (1895)
Floor End.
Wood Parts Hardware
Notice bolt holes
on this side.
7x 1/4x2”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
1x 1/4x3”LagScrew(1/4”atwasher)
2x 1/4x1-1/2”LagScrew(1/4”atwasher)
1 x Floor End 1 x 5 x 35-1/4”
1 x Ground SW 1 x 5 x 68-7/16”
2 x Post 2 x 4 x 81”
1 x Lower Diagonal 2 x 3 x 37”
1895
0369
1931
1933
LS1
H2
LS3
1931
H2
Fig. 10.1
1/4” lock
washer
1/4” at
washer
1/4” t-nut
LS1
0369
1933
1931
1895
H2
H2
H2
H2
Fig. 10.2
1931
1931
1895
LS3
1/4” at
washer
LS1
1/4” at
washer
0369