Owner Manual
26
Step 10: Swing Wall Assembly
Part 2
C: Place (1935) Side Roof on both (1931) Posts as shown in g. 10.3.
D: Place (1938) Wall Mount across (1895) Floor End and (1935) Side Roof, make sure to use the hole in the
Side Roof that measures 16-1/4” from the hole on the shorter overhang edge as shown in g. 10.4. Attach using
2 (G4) 5/16 x 4” Hex Bolts (with lock washer, at washer and t-nut) as shown in g. 10.4.
E: Attach (1935) Side Roof to both (1931) Posts using 2 (H2) 1/4 x 2” Hex Bolts (with lock washer, at washer
and t-nut). (g. 10.4)
F: Tighten all (H2) bolts from this step, keeping (G4) bolts loose.
Wood Parts Hardware
Notice
overhang at
the top
Fig. 10.4
1895
Fig. 10.3
G4
H2
1931
1935
1938
1931
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
2x 1/4x2”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
2x 5/16x4”HexBolt(5/16”lockwasher,5/16”atwasher,5/16”t-nut)
1 x Side Roof 1 x 4 x 55-1/8”
1 x Wall Mount 2 x 4 x 37-1/2”
1935
1938
G4
H2
5/16”Flat
Washer
5/16”” Lock
Washer
5/16”
T-Nut
Notice longer extension on this side
16-1/4”
H2
G4