Owner Manual

27
H12
1931
1937
1931
H6
1908
Fig. 11.2
Step 11: Front Frame Assembly
Part 1
A: On the front side of the assembly, from the inside, attach (1908) Front Floor to each (1931) Post with 2 (H6)
1/4 x 4-3/4” Hex Bolts (with lock washer, at washer and t-nut). (g. 11.1 and 11.2)
B: Flush to the bottom of (1908) Front Floor attach (1937) Centre Divider with 1 (H12) 1/4 x 3” Hex Bolt (with
lock washer, at washer and t-nut). (g. 11.2)
C: Attach (1937) Centre Divider to (1906) Top Front Back using 1 (H2) 1/4 x 2” Hex Bolt (with lock washer, at
washer and t-nut). (g. 11.3)
D: Make sure (1906) Top Front Back is square and level and then attach to both (1931) Posts using 4 (S7) #12 x
2” Pan Screws (with 3/16” at washers). (g. 11.3)
Wood Parts Hardware
Front
Fig. 11.1
Window Wall
1x 1/4x3”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
4x #12x2PanScrew(3/16”atwasher)
1x 1/4x2”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
2x 1/4x4-3/4”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
1 x Top Front Back 1 x 4 x 38-1/2”
1 x Front Floor 2 x 3 x 38-1/2”
1 x Centre Divider 2 x 2 x 31-3/4”
1906
H12
1908
1937
Swing Wall
S7
H2
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
H6
1937
H2
Fig. 11.3
1906
1931
1931
with 3/16”
at washers
with 3/16”
at washers
S7
S7
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
H6