Owner Manual

34
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws.
D: Attach (1936) MK Mount to (1906) Top Front Back using 1 (H12) 1/4 x 3” Hex Bolt (with lock washer, at
washer and t-nut). (g. 16.4)
E: Make sure (1906) Top Front Back is level and then attach to both (1931) Posts using 4 (S7) #12 x 2” Pan
Screws (with 3/16” at washers). (g. 16.4)
F: Attach (1768) Lower Back to the bottom of (1931) Posts with 2 (LS3) 1/4 x 3” Lag Screws (with at washer) in
the top (pre-drilled) holes and 2 (S7) #12 x 2” Pan Screws (with 3/16” at washers) in the bottom holes as shown
in g.16.5.
Step 16: Back Wall Assembly
Part 2
Wood Parts Hardware
S7
Fig. 16.5
Fig. 16.1
1768
S7
LS3
LS3
1931
2x 1/4x3”LagScrew(1/4”atwasher)
1x 1/4x3”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
6x #12x2PanScrew(3/16”atwasher)
1 x Lower Back 1 x 5 x 38-1/2”
1 x Top Front Back 1 x 4 x 38-1/2”
1768
LS3
with 3/16”
at washer
with 3/16”
at washer
1/4” at
washer
S7
Fig. 16.4
with 3/16”
at washer
H12
S7
with 3/16”
at washer
1931
1931
1/4” at
washer
1/4”
t-nut
1/4” lock
washer
1936
1906
1906
H12
S7
1931