Owner Manual
49
Hardware
Other Parts
Step 27: Connect Monkey Bar Assembly to Fort
Part 1
A: With a MK Bracket attach (1565) MK Rail Short to (1936) MK Mount with 1 (G10) 5/16 x 3” Hex Bolt (with lock
washer, at washer and t-nut) and 4 (S6) #12 x 1” Pan Screws, as shown in g. 27.1 and 27.2.
B: Measure 21-1/4” from top of (1943) MK Rail Long to top of (1890) CE Gap Board, then with a MK Strap attach
(1943) MK Rail Long to (1931) Post using 1 (LS2) 1/4 x 2-1/2” Lag Screw (with at washer) in the centre hole and 2
(S6) #12 x 1” Pan Screws in the 2 end holes as shown in g. 27.3.
C: Tighten the top bolt in (1936) MK Mount.
Pre-drill all pilot holes using a 1/8” drill bit before installing the lag screws and pan screws.
1936
Fig. 27.1
1x 5/16x3”HexBolt(5/16”lockwasher,5/16”atwasher,5/16”t-nut)
1x 1/4x2-1/2”LagScrew(1/4”atwasher)
6 x #12 x 1” Pan Screw
S6
G10
1 x MK Bracket
1 x MK Strap
S6
MK Strap
1943
Fig. 27.3
LS2
1/4” Flat
Washer
LS2
x 4
1931
1890
21-1/4”
Fig. 27.2
MK Bracket
1936
5/16” Flat
Washer
5/16” Lock
Washer
5/16”
T-Nut
1565
G10
S6
1931
Pg 49 image update
1943
1565