Owner Manual

53
Step 30: Sand and Water Table Wall Assembly
Part 1
A: Loosen the 4 bolts indicated on (1932) Side Ground, in g. 30.2, then tuck the Hampton Tarp between the
(1931) Posts and (1932) Side Ground, down to the top of the bolts, 1” from top of board.
B: From outside the assembly, measure 4” up from the top of (1932) Side Ground, on both sides, and attach to
both (1931) Posts, 1/2” in from the edge of the tarp, with 2 (S5) #8 x 1/2” Pan Screws (with #8 at washer). (g.
30.2)
C: Measure 8” up from the screws and attach to both (1931) Posts, 1/2” in from the edge of the tarp, with 2 (S5)
#8 x 1/2” Pan Screws (with #8 at washer). (g. 30.2)
D: From the inside the assembly and 1/2” in from the edge of the tarp, attach to (1932) Side Ground with 4 evenly
spaced (S5) #8 x 1/2” Pan Screws (with #8 at washer). (g. 30.3)
E: Tighen the previously loosened bolts.
Hardware Other Parts
1931
Loosen these bolts
S5
1932
Fig. 30.2
Fig. 30.3
1931
Fig. 30.1
S5
S5
1932
Evenly Spaced
8x #8x1/2”PanScrew(#8atwasher)
S5
1 x Hampton Tarp
8”
4”
1”
S5
Hampton Tarp
pg 53 image