Assembling & Installation Instructions

ManualsBrandsThree Posts ManualsLightingCarlin 1-Light Candle Wall Light

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box. Carefully unpack your new fixture and lay

out all the parts on a clear area. Take care not to lose any small parts

necessary for installation.

2. Thread the two mounting screws about 1/4” into the pre-drilled holes in

the mounting plate, spaced about the same distance apart as the holes

in the fixture back plate. Attach the mounting plate to the junction box

using two junction box screws as shown. The side of the mounting

plate marked “GND” must face out. The junction box is not included.

3. Follow wiring instructions carefully(see fig.2).

4. Raise the back plate onto the mounting plate, aligning the mounting

holes with mounting screws, then lock it securely with the ball nuts (C).

5. Slide the shim(A) onto the lamp holder.

6. Install the light bulb(Not included) in accordance with the fixture’s

specifications.

DO NOT EXCEED THE MAXIMUM WATTAGE

RATING!

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from the

fixture to the black house (hot) Wire. Connect the white wire from the

fixture to the white (neutral) house wire. Make sure all wire nuts are

secured. You may wrap the connections with electrical tape. If your

outlet box has a ground wires (green or bare copper) connect fixture’s

ground wire to it. Otherwise attach the bare copper fixture wire to the

green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

FIG.1

Thank you for purchasing our product.

Need assistance with parts or assembly? Please call customer service.

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. FIG.1 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area.