Installation & Assembly

i) Place table top upside down on soft surface. Align and fasten support bar to

table top using short bolt(H), spring washer(J) and flat washer(K) and fully

tighten with Allen wrench(G). Which unloose from step 1 and tighten with

Allen wrench(G).

ii) Align and fasten upper trestle bar(D) to table top(A) using screw(M) and

fully tighten with screw driver (Not Included).

** Do not fully tighten the nut or bolt until all nuts and bolts are attached.

Stand table up on an even surface and check

that it is balanced. If there is a slight wobble,

please adjust the leveler.

Cleaning & Care

Treat Surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface with a

dry or damp soft cloth. Do not use abrasive cleaners . Hardware may loosen over time. Periodically check

that all connections are tight.