Assembly & Installation Instructions

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
1. Thread two headless screws through the mounting plate, and then secure them with four lock nuts (two on each
side of the mounting plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally to make the fixture level.
2. Attach mounting plate to the outlet box using two mounting screws.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding screw, and then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
Turn off the power at fuse or circuit box.
Installation Steps
Back Plate
Wire Nut(E)
Fixture Wire
Ball Nut (G)
Socket
Fabric Shade
Mounting Screw (B)
Wire Nut (E)
Ball Nut (G)
Lock Nut (F)
Headless Screw(D)
Green Grounding
Screw (C)
Bulb Type B Max.60W
(not included)
Outlet Box
Green Grounding Screw (C)
Headless Screw (D)
Mounting Plate (A)
Mounting Screw (B)
Lock Nut (F)
Fixture Grounding Wire
House Grounding Wire
Mounting Plate (A)