Caution: You must read this before you proceed.
Before Beginning Assembly: Unpack all the parts for a clear overview. Overview Table Top(A) Leg Panel(B) Leg Support Panel(C) This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all the parts on a clean, non-marring surface. Turn table top upside down,then attach Leg Panels (B) to the Table Top(A) using Bolt(F) and Washer(E) with Allen Key(D) as shown in the picture above. Repeat this process with the other Leg Panel (B) Do not fully tighten the Bolts. Step 2 Attach Leg Support Panel(C) between Leg Panels(B) using Bolt(F) and Washer(E) with Allen Key(D) as shown in the picture above.
Step 3 If wobble Test again 30CM~50CM Place the table on a LEVEL SURFACE to check for wobbles. 20cm to 50cm 30cm height from the ground. If it wobbles,with 2 to 3 adult partners, lift the table to some 30cm Keep your feet and toes well away from the drop zone. Drop the table freely and vertically with the four legs, hitting the ground, all at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE.
Do not put hot items directly on furniture surface Do not clean furniture with harsh cleansers or polish. To obtain the longest lifespan of your outdoor prodcts, minimizing exposure to direct sunlight is recommended. Children should not climb or jump on the furniture. Do not write on furniture without a padded barrier to protect the surface. To obtain the longest lifespan of your outdoor products, avoid extended and lengthy exposure to rain, snow, and direct sunshine.
