Assembling &Installation Instructions

ManualsBrandsThree Posts ManualsCeiling LightsAnalia 7 - Light Shaded Drum Chandelier

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and

all hardware from Junction Box. The junction box is not include.

2. Carefully unpack your new fixture and lay out all the parts on a clear

area. Take care not to lose any small parts necessary for installation.

3. Slide the electrical wires through the tubes(E)/(D)/(C)/(B) and

canopy(A) .

4. Raise the tube (E) to top screw pipe of shade (F), raise the tube

(D) ,tube (C) ,tube (B) and canopy(A) to the screw pipe in order , then

by turning it clockwise until tight.

6. Thread the two mounting screws into the pre-drilled holes in the

Mounting plate spaced the same distance apart as the holes in the

canopy (A).

7. Attach the Mounting plate to the Junction Box with the two Junction

Box screws as shown. The side of the Mounting plate marked "GND"

must face to out.

8. While holding the fixture lamp towards the ceiling , connect the

electrical wires as Shown in Fig.2, making sure that all wire nuts are

secured. You may have to wrap the connections with electrical tape.

If your outlet has a ground wire (green or bare copper), connect the

fixture ground wire to it. Otherwise connect fixture’s ground wire

directly to the Mounting plate with the green screw provided. After

wires are connected, tuck them carefully inside the Junction Box.

9. Raise the canopy (A) on to the Junction box, aligning screws on

mounting plate with mounting holes in canopy and lock it securely

with the ball nuts.

Your installation is now complete. Return power to the junction box

the fixture.

Mounting plate

Mounting screw

Fixture

Junction Box

(Not include)

Ground

Wire

Ground Wire

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

FIG.1

5. Install the light bulbs(Not included) in accordance with the fixture

specifications. NOTE: DO NOT EXCEED THE SPECIFIED

WATTAGE!

Thank you for purchasing our product.

Need assistance with parts or assembly? Please call customer service