Assembly Instructions

Page 1 of 2

MADE IN MALAYSIA

PART NO

FIGURE

DESCRIPTION

Q'TY

Wood Seat

Chair Back

PARTS LIST

1 Pce

Hardware Bag

Front Leg (Right)

1 Pce

Front Leg (Left)

2 Pcs

Side Stretcher (L / R)

Caution: Please read instructions thoroughly before unpacking assembly parts. Sharp, exposed staple tips can cause

injury, therefore, for your protection, please remove any exposed staples used in packing.

Please keep all hardware parts out of the reach of children.

1.We recommend that you should assemble this product with the assistance of another person; this will make assembly easier,

and will help to eliminate damage to the product or injury to persons during assembly.

2.B e sure to check all packing materials carefully f or small parts that may have come loose inside the carton during shipment.

3.Please do not over tighten screws or bolts.

4.Please put all parts on a non-abr asive floor before assembly, and follow the assembly steps to assemble your newly purchased

product correctly and efficiently.

P A R T S L IS T

PAGE 1
PARTS LIST Caution: Please read instructions thoroughly before unpacking assembly parts. Sharp, exposed staple tips can cause injury, therefore, for your protection, please remove any exposed staples used in packing. Please keep all hardware parts out of the reach of children. 1.We recommend that you should assemble this product with the assistance of another person; this will make assembly easier, and will help to eliminate damage to the product or injury to persons during assembly. 2.
PAGE 2
Hardware List : 8x1.1/4" Pan Head Screw 4 pcs M6x40mm JCBC Bolt 2 pcs M6x70mm JCBC Bolt 6 pcs M6x13mm Lock Washer 8 pcs M6.5x16.5mm Flat Washer 8 pcs Allen Key 1 pce Glue 1 pce ASSEMBLY: ST E P 1: A ttached W ood Seat to Chair B ack using the provided hardware as shown on Fig 1.1 A nd Fig 1.2. ST E P 2: A ttached Front leg (L eft & R ight ) to W ood Seat using the provided hardware as shown on Fig 2.1.