Assembly Instructions

MADE IN MALAYSIA
PAGE 2 OF 3
STEP 2
NOTE : THE UNIT SHOULD BE ASSEMBLED BY 2 OR MORE PEOPLE.
ASSEMBLY
STEP 1
Hex Nut
Hex Nut
12 pcs
Lock Washer
Lock Washer(Large)
Large
12 pcs
Flat Washer
Flat Washer(Large)
Pedestal
Leg
Level Glide
Large
12 pcs
Lock Washer
Small
8 pcs
Flat Washer
Small
8 pcs
Wrench
Wrench
1 pc
Allen Key
1 pc
JCBC Bolt
8 pcs
HARDWARE PART :
Turn the pedestal upside down. Attach legs by inserting
hanger bolts through pre-drilled holes on pedestal.
Put a Flat Washers(Large), Lock Washers(Large)
and Hex Nuts onto the hanger bolts then tighten with
the provided Wrench.Turn the Base Right side up.
Position the table top upside down on a smooth, protective
surface such as carpet. Remove and discard the temporary
Wood Strip. Install the side panel and secure with
Flat Washers(Small), Lock Washers(Small) and
JCBC Bolt. Attach Mounting Plate as shown. Secure
with Flat Washers(Small), Lock Washers(Small) and
JCBC Bolt, then tighten all JCBC Bolts with Allen Key
provided.
STEP 3
Unlock the hooks underneath the table and pull the table top wide
open equally from both ends. Align and attach the table top to the
pedestal. Insert a Flat Washers(Large), Lock Washers(Large)
and Hex Nuts onto the hanger bolts. Tighten all Hex Nuts with the
provided Wrench.
Lock Washer(Small)
Lock Washer
(Small)
Allen Key
Allen Key
JCBC Bolt
JCBC Bolt
Flat Washer(Small)
Flat Washer
(Small)
Mounting Plate
Side Panel
Lock Washer(Large)
Flat Washer(Large)
Wrench
Hex Nut
Unlock Hook
CARE INSTRUCTION
~ Be sure to use the same type of polish consistenly.
Your furniture will appear cloudy or streaky if oil
based or wax based polishes are interchanged.
~ Spray your furniture surface evenly. Wipe in a
circular motion with a soft clean cloth.
Remove Wood Strip
SOLID TOP BUTTERFLY LEAF PEDESTAL TABLE