Installation & Assembly

11
Partially insert three blade screws
along with three blade washers
through one blade and into one
blade arm. Tighten each blade
screw, starting with the one in the
middle. Repeat this step for the
remaining blades and blade arms.
Install the blade arm to the underside
of the motor assembly with the ten
previously removed motor screws.
Note: To install a light kit
(optional), proceed to the page 13.
3. Attach blades to blade arms. 4. Attach blade arms to motor.
X 15
FINAL INSTALLATION
5. Install the switch housing cap.
Blade Screw
Blade Arm
Blade Arm
Motor Screw
Blade
Blade Washer
X 10
Remove the three switch housing
screws from the switch housing cap.
Attach the switch housing cap to the
switch housing using the three switch
housing screws.
Switch
Housing
Screw
Switch Housing
Reverse Switch
Switch Housing
Cap
Notch
Note: Align the notch in the switch housing
cap with the reverse switch.
X 3