CEILING FAN LIGHT KIT
PACKAGE CONTENTS 7 6 Unpack your fan and check the contents. You should have the following items: 1 1. Light Kit 2 PACKAGE CONTENTS 5. Owner’s Manual 2. Socket Ring (x 3) 6. Lock Washer 3. Glass Shade (x 3) 7. Hex Nut 4.
SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE BEGINNING TO INSTALL THE LIGHT KIT AND SAVE INSTRUCTIONS. This fixture is intended for use with an indoor ceiling fan. Not suitable for damp or outdoor locations. The fan images and instructions in this manual are generic, but in most cases the installation will be easy to follow. If unsure about installation, consult a qualified licensed electrician for proper installation. The net weight of the light kit is less than: 4.
ASSEMBLY INSTRUCTIONS 1. Turn OFF the electrical power at the main fuse or circuit breaker. 1 A Fitter Plate Switch Housing B Switch Housing Cap 2 Switch Housing A Switch Housing Switch Housing Screw 3 B Switch Housing Cap Note: Save the three switch housing screws for later. 4. Use a screwdriver to push the plug button out of the switch housing (A) or switch housing cap (B). Plug Button B Switch Housing Cap 3.
ASSEMBLY INSTRUCTIONS 5. Remove the three socket rings from the sockets and save for later. 5 Socket Ring A B Hex Nut Lock Washer Hex Nut Lock Washer 6 A Single-pin Connector 9-pin Connector 7 B 6. Remove the hex nut and lock washer from the threaded rod at the top of the light kit. Then, insert the wires and threaded rod from the light kit through the center hole in the switch housing (A) or the switch housing cap (B).
ASSEMBLY INSTRUCTIONS 9. Lift the glass shade over the socket. Then screw the socket ring onto the socket to secure the glass shade. Socket Glass Shade 9 Socket Ring 10. Install the E26-base LED bulbs into the sockets. 10 Bulb 11. Restore the power at the main fuse or circuit breaker.
TROUBLESHOOTING WARNING: Ensure the power is turned off to the ceiling fan and light kit before performing any maintenance. PROBLEM SUGGESTED REMEDY Fixture does not light up. 1. Turn on wall switch, and check fuses or circuit breakers. 2. Check wire connections from fan to light kit, located in the switch housing of the ceiling fan. 3. Lower the canopy on the fan. Ensure the blue fan wire (light power) is connected to a black (hot/live) household supply wire. Re-install the canopy.
