Installation & Assembly (Light Kit)

ASSEMBLY INSTRUCTIONS
5
9-pin
Connector
Single-pin Connector
Single-pin
Connector
A
B
7
Lock
Washer
Lock
Washer
Hex Nut
Hex Nut
A B
5
6
5. Remove the three socket rings from the sockets and
save for later.
6. Remove the hex nut and lock washer from the threaded
rod at the top of the light kit. Then, insert the wires
and threaded rod from the light kit through the
center hole in the switch housing (A) or the switch
housing cap (B). Secure the switch housing (A) or switch
housing cap (B) to the light kit using the lock washer and
hex nut.
7. Use the single-pin connectors to connect the wires from
the light kit to the wires in the switch housing (A or B) --
black to blue and white to white.
If your fan has a tter plate (A), you may also need to
connect the 9-pin connector from the fan to the 9-pin
connector from the switch housing.
A
B
8
8. Using the three previously removed switch housing
screws, reattach the switch housing to the tter plate (A)
or the switch housing cap to the switch housing (B).
Socket Ring
Switch
Housing
Screw
Switch
Housing
Screw