Assembly Instructions

Page 2 of 2
1. Temporarily locate the furniture to near it's final location in the room next to a wall. Locate a wall
stud behind your furniture and also mark the stud's location on the back of your furniture.
2. Firmly attach one bracket to the stud approximately 2" below the top of the furniture with the
2 inch long Wood Screws provided. It may be necessary to drill 3/32 dia. pilot holes for the screws.
3. Firmly attach the other bracket onto a solid, structural part on the back of the furniture using the 5/8
inch long Wood Screws. It may also be necessary to pilot bore for these screws.
4. Move the furniture into its final position, taking care to line up the wall bracket with the furniture
bracket. Thread a strap through the bracket as shown in the illustration. Tighten strap until snug
but do not over tighten.
Approximately
2"
Install screws
through the small
hole in brackets
5/8 inch
Screw
5/8 inch
Screw
Wall Stud
Anti-Tip Hardware
Installation Instructions
Notice: This manufacturer recommends that steps be taken for certain furniture items toprevent
or minimize the risk of tip-over. This furniture is equipped with Tip-over Restraint Hardwarefor use
to minimize this risk, if used. Please follow below installation steps. This manufacturer recommends
that parents and guardians periodically visit the U.S. Consumer Product Safety Commission (CPSC)
website at http://www.cpsc.gov/ and stay up to date on all issues related tochildren's product
safety.
Caution: This manufacturer assumes no liability for improper installation or excessive loadsplaced
on screws, brackets or straps. Failure to detach this restraint before moving furniture mayresult
in personal injury and property damage.
Warning: This tip-over restraint is not to be a substitute for proper adult supervision. Do not allow
children to climb on furniture. Items left on top of the TV and furniture, such as toys, remote
controls and treats might tempt young children to climb. Push the TV as far back as possible from
the front of its stand. Place electrical cords out of a child's reach, and teach children not to play with
the cords.