Assembly Instructions

Lock
Unlock
Components and Hardware List
Made in Viet Nam
Page 1 of 1
Leg
A
To prevent possible scratches and damage, this furniture must be assembled by two people on a soft
surface such as a blanket or carpet.
Step 1: Place the Table Top upside down. Attach a Leg (A) into each corner of the Table Top using the 2-1/4"
Allen Head Bolts (D), Spring Washers (E) and Flat Washers (F). Tighten using the Allen Wrench (G). Install
the Levelers (H) into the bottom of the Legs, if they are not already installed. Carefully set the Table upright.
Step 2: To install the Table Top Leaf, reach underneath the sides of the Table Top and twist the handle of the
Locks to unlock. Using two people, lift the table off the floor, and pull the two halves of the Table Top open,
place the Leaf in position, aligning the pins with the holes on the edges and push the halves back together.
Reach underneath the Table Top and relock.
To prevent undue stress on the Dining Table, using two people, always lift and carry your Dining Table
from one location to another.
4 pcs.
B
C
D
E
F
Table Top Top Leaf
M5/16"-18 x 2-1/4"
Long
Allen Head
Bolt
5mm Allen
Wrench
5/16"*19*2mm
Flat Washer
5/16" Spring
Washer
1 pc. 1 pc.
G
8 pcs. 8 pcs. 8 pcs.
1 pc.
Be sure to check all packing material carefully for small parts, which may have come loose inside the carton
during shipment.
D
E
F
G
Step 2
Lock
Unlock
Step 1
A
B
B
C
H
Leveler
4 pcs.
H
Dining Room
Assembly Instructions
Dining Table