Assembly Instructions Caution: You must read this before you proceed CHAIR Caution: This Chair is NOT a TOY Keep your child/ children at bay during the assembly process. Whenever moving/lifting the Chair and to prevent damage to the Chair two adults are needed to execute these actions.
Parts List Label Picture Description QTY A Backrest Panel 1 B Right Leg Panel 1 C Left Leg Panel 1 D Seat Panel 1 E Seat Cushion 1 Description QTY ① Bolt (M6x75mm) 9 ② Bolt (M6x35mm) 9 ③ Spring Washer (M6.5x2mm) 13 ④ Washer (M6.
Assembly Preparation Before Beginning Assembly: Assembly Steps Overview Backrest Panel (A) Seat Cushion (E) Right Leg Panel (B) Seat Panel (D) Left Leg Panel (C) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 Place the Left Leg Panel(C) facedown onto a clean, non-marring surface. Attach the Backrest Panel(A) to Left Leg Panel(C) using Bolts(②) with Allen Key(⑤). Do not fully tighten the Bolts.
Step 3 3.1) Attach Seat Panel(D) to Left Leg Panel(C) using Bolts(②), Spring Washers(③), and Washers(④) with Allen Key(⑤). 3.2) Attach Seat Panel(D) to Left Leg Panel(C) using Bolts(①), Spring Washers(③), and Washers(④) with Allen Key(⑤). Do not fully tighten the Bolts.
Step 4 With assistance from your adult partners, align assembled frame from Step 3 to Right Leg Panel(B). 4.1) Attach Backrest Panel(A) to Right Leg Panel(B) using Bolts(②) with Allen Key(⑤). 4.2) Attach Seat Panel(D) to Right Leg Panel(B) using Bolts(②), Spring Washers(③), and Washers(④) with Allen Key(⑤). 4.3) Attach Seat Panel(D) to Right Leg Panel(B) using Bolts(①), Spring Washers(③), and Washers(④) with Allen Key(⑤). Do not fully tighten the Bolts.
Step 5 Place the Chair on a LEVEL SURFACE. Gently and gracefully, sit into to the Chair. This pressure will help the Chair reach full alignment at all joints. In a sequential manner, gradually tighten all Bolts until evenly secured. When tightening the Bolts tighten sequentially. DO NOT tighten any Bolt fully and then move on towards the next one. If there are still wobbles, loosen the Bolts and execute this same process. Step 6 Place Seat Cushion(E) into the Chair as shown above.
____
