Installation Guide

2of2
STEP 4 - Install the Fixture Body
A. Place the ceiling canopy of the Fixture Body (B) onto the nipple and
secure with previously removed mounting ball. Hand tighten until
snug.
FINISH: BRUSHED NICKEL
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
Figure 4
STEP 6 - Install Bulbs
A. s sInsert vintage bulb (F) onto socket and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Figure 5
Nipple
Mounting Ball
B
STEP 5 - Install Support Rods, Glass Shade and Ring
A. Thread Support Rods (C) onto nipples on the bottom of the Fixture
Body (B). Hand tighten until snug.
B. Remove lock balls from bottom ends of Support Rods (C).
C. Place the Glass Shade (D) over Support Rods (C) and place the
Ring (E) onto the Support Rods (C). Secure them to the Fixture Body
(B) by threading previously lock balls onto Support Rods (C). Hand
tighten until snug.
C
D
E
Lock Ball
B
Figure 6
Nipple
12” Dia.
9” Dia.
4.25”
5.75”
Socket
F