Installation & Assembly

ASSEMBLY INSTRUCTION

ROUND DINING TABLE

fcS TABLE TOP m MOUNTING PLATE HI PEDESTAL COLUMN

^S==- ===î? (COQ

1 PC 1 PC 1 PC

| | ALLEN WRENCH U JCBC M6 x 50mm H i SPRING WASHER M6

1 PC 6 PCS 6 PCS

| | WRENCH 13mm I I HEX NUT 5/16" 13 SPRING WASHER M8

1 PC

__________________

12 PCS

_____________________

12 PCS

m LEVELER

4 PCS

||] PEDESTAL LEG

4 PCS

|£ | FLAT WASHER M6

Cs>

6 PCS

II FLAT WASHER M8

12 PCS

This Page lists all the contents included

in the box . Please take the time to

identify the hardware as

well as the individual components to this

product. As you unpack and prepare for

assembly, place

the contents on a carpeted or padded

area to protect them from damage .

PAGE 1
ASSEMBLY INSTRUCTION ROUND DINING TABLE fcS TABLE TOP m MOUNTING PLATE H I PEDESTAL COLUMN ^S==- ===î? 1 PC | | ALLEN WRENCH | | ] PEDESTAL LEG (COQ 1 PC U JCBC M6 x 50mm 1 PC 4 PCS H i SPRING WASHER M6 |£ | FLAT WASHER M6 Cs> 1 PC | | WRENCH 13mm 6 PCS 6 PCS I I HEX NUT 5/16" 1 3 SPRING WASHER M8 1 PC__________________ 12 PCS_____________________ 12 PCS 6 PCS II FLAT WASHER M8 12 PCS m LEVELER 4 PCS This Page lists all the contents included in the box .
PAGE 2
1 Align and fasten mounting plate(B) to pedestal column(C) using hex nut(J), big spring washer(K) and big flat washer(L) and tighten with wrench(I). I I Place table top upside down on soft surface. A lign and fasten mounting plate(B) to table top(A) using bolt(F), small spring washer(G) and small flat washer(H) and tighten with A llen wrench(E). ** D o not fully tighten the nut or bolt until all nuts and bolts are attached.
PAGE 3
Screw in the leveler(M ) to the bottom o f pedestal leg(D). A lign and fasten pedestal leg(D ) to pedestal colum n(C) using hex nut(J), big spring washer(K), and big washer(L) and tighten with wrench(I). Stand table up on an even surface and check that it is balanced. If there is a slight wobble, please adjust the leveler. Cleaning & Care Treat Surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface with a dry or damp soft cloth. Do not use abrasive cleaners .