Owner Manual

1. Attach Lid Supports 8 into pre-drilled holes of Seat B and Divider E

using Phillips Screws Round Head 5

( left and right )

ASSEMBLY

STEP 6

NOTE: The screwdriver is not

included in the hardware pack.

1. Attach Seat B to 3 Hinges on Back D using Phillips Screws 6

( using guide holes underneath of Seat ).

2. Use phillips screwdriver to tighten Screws. Do not over-tighten.

STEP 7

Lid Support-Left

Lid Support-Right

2. Use phillips screwdriver to tighten Screws. Do not over-tighten.

12/13