Owner Manual

1. Attach ( left and right ) Lid Supports 8 into pre-drilled holes of Seat A and Divider E
using Phillips Screws Round Head 5 .
2. Use phillips screwdriver to tighten Screws. Do not over-tighten.
13/14
ASSEMBLY
STEP 6
NOTE: The screwdriver is not
included in the hardware pack.
1. Attach Seat A to 3 Hinges on Back D using Phillips Screws 6
( using guide holes underneath of Seat ).
2. Use phillips screwdriver to tighten Screws. Do not over-tighten.
STEP 7
8
5
8
5
Lid Support-Left
Lid Support-Right
A
A
D