Owner Manual

CAUTION: IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
• Do not use seasonal products outdoors
unless marked suitable for indoor and
outdoor use. When products are used
in outdoor applications, connect the
product to a Ground Fault Circuit
Interrupter (GFCI) outlet. If one is not
provided, contact a qualified electrician
for proper installation.
• This seasonal use product is not intend-
ed for permanent installation or use.
• Do not mount or place near gas or
electric heaters, fireplaces, candles or
other similar sources of heat.
• Do not secure the wiring of the product
with staples or nails, or place on sharp
hooks or nails.
• Unplug the product when leaving the
house, when retiring for the night, or if
left unattended.
• Do not let lamps rest on the supply cord
or any wire.
• CAUTION: This is an electrical product
– not a toy! To avoid risk of fire, burns,
personal injury and electric shock, it
should not be played with or placed
where small children can reach it.
• Do not use this product for other than its
intended use.
• Do not hang ornaments or other objects
from cord, wire or light string.
• Do not close doors or windows on the
product or extension cords as this may
damage the wire insulation.
• Never operate this product if the power
cord or plug is damaged.
• Use only manufacturer specified
replacement bulbs.
• Read and follow all instructions that are
on the product or provided with the
product.
USE AND CARE INSTRUCTIONS
• When storing the product, carefully
remove the product from wherever it is
placed, avoiding any undue strain or
stress on the product conductors,
connections, and wires.
• When not in use, store neatly in a cool,
dry location protected from sunlight.
A2
A2
B2
B2
A1
B1
B1
A1
SIDE 2
CENTER
SIDE 1
IMPORTANT NOTE: Some unassembled section pieces
have light string wires strung between them. Be careful
not to put unnecessary strain on the wires during
assembly procedures.
Assembly
1. (Diagram 1) Assemble the upper sleigh by inserting the
four rods of the center sleigh section into the loops on
the side sections. A1 rods into B1 loops. A2 rods into
B2 loops.
2. (Diagram 2a) Insert the five rods located on SIde 1 into
the corresponding loops on the lower sleigh section.
Repeat this procedure for opposite side.
Diagram 1 Diagram 2a
Diagram 2b Diagram 3
Secure display with ground stakes at
points shown by dots (
•
).
3. (Diagram 2b) Insert the ends of the three hinged hooks
located in the sleigh lower section into the loops on the
opposite side.
4. Attach ornament bow as shown in diagram. Position as
desired.
Optional: Tie wraps are included to bind larger sections
together for added security. Place where desired.
Secure the assembled piece to the ground using the
supplied stakes (Diagram 3). Plug light strings cords into
a power supply. Plugs can be “piggy-backed” - - plugged
into each other, and then into a receptacle.