Assembly Instructions - Table
STEP 1
Assembly Instructions 2/3
A
E
B
Attach Top (A) with (B), by aligning dowels with the holes and firmly
pushing together.
Engage the locks by turning their handles clockwise ΒΌ turn
(see Figure 2).
Attach Table Slides (D) to the unit using Head Cap Bolts,
Spring Washers(Small) and Flat Washers(Small).
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
*
You should keep Hex Wrench, Key Wrench in a safe place as you may need to tighten up the Bolts in the future.
Place Top (A) and (B) face side down
on a soft cloth.
Remove Table Slides (D) from their packing position by loosening
and removing Head Cap Bolts, Spring Washers(Small) and
Flat Washers(Small) using Hex Wrench.(see Figure 1)
Note: These 4 Head Cap Bolts, Spring Washers(Small) and Flat Washers(Small)
will be used in Step 2.
DO NOT DISCARD
D
D
A
D
B
D
STEP 2
Figure 2
Figure 1
Hex Wrench
Head CapBolt
Spring Washer(Small)
Flat Washer(Small)
Head Cap Bolt
Spring Washer(Small)
Flat Washer(Small)