Caution : You must read this before you proceed Club Chair Label Picture Description QTY A Chair Back 1 B Chair Base 1 Page 1 OF 6
C Front Leg 2 D Back Leg 2 Description QTY Gasket 7 Label ① Picture Page 2 OF 6
Chair Back (A) Chair Base (B) Front Leg (C) FRONT FACING This Club Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Club Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Chair Base (B) Place the Chair on its back on a clean, non-marring surface as pictured above.
Step 2 Chair Back (A) Chair Base (B) Position yourself behind the Chair and place the Chair Back(A) into the Chair Base(B). Tilt the Chair Back slightly forward, then gently pull the Chair Back towards you while pushing it down all the way into the Chair Base.
Step 4 Front Leg(C) Gasket(①) Front Leg(C) Back Leg(D) Back Leg(D) Install Front Leg(C) into the Chair Base(B) by putting a Gasket(①) on the threaded stem. Then insert the threaded stem into the mounting position at the corner of the bottom of Chair Base(B). Tighten by turning the Front Leg(C) clockwise by hand. Repeat the same process to install the remaining Front Leg(C) and Back Leg(D). The use of Gaskets are OPTIONAL and are especially useful to help alleviate slight wobbles.
Page 6 OF 6
