Installation & Assembly

Page 1 of 3

Adult Assembly

PRINTER STAND

READY

PRINTER STAND

Hexagon Wrench

Flat washer - 8 pcs Wooden Dowel 3/8 X 1 1/4” - 4 pcs

Wooden Dowel 1/4” X 1 1/4” - 4 pcs

Spare - 2 pcs

Spare - 1 pc

Hexagon nut - 8 pcs Wood Screw - 6 pcs

Spare - 2 pcs

Spare - 1 pc

Hexagon wrench - 1 pc

NOTE: WE INCLUDE SPARE HARDWARE IN CASE THE HEXAGON NUT, WASHER, WOODEN DOWEL

OR WOOD SCREW ARE DAMAGED DURING ASSEMBLY.

PARTS LIST

TOP PANEL 1 PC

4 PCS

2 PCS

1 PC

LEG

SIDE PANEL

LOWER SHELF

ASSEMBLY INSTRUCTIONS

Before assembling your Printer stand, please read through these

instructions carefully. Familiarize yourself with the different parts.

PAGE 1
READY PRINTER STAND ASSEMBLY INSTRUCTIONS Before assembling your Printer stand, please read through these instructions carefully. Familiarize yourself with the different parts. Hexagon Wrench Adult Assembly NOTE: WE INCLUDE SPARE HARDWARE IN CASE THE HEXAGON NUT, WASHER, WOODEN DOWEL OR WOOD SCREW ARE DAMAGED DURING ASSEMBLY.
PAGE 2
STEP 1 Attach the legs (02) to the top panel (01) as shown below using flat washers (A) and hexagon nuts (B), tighten with hexagon wrench (C). 02 A B 02 A 02 02 Adult Assembly B 02 01 A B B A STEP 2 STEP 3 Install wooden dowels (D)(E) into the locator holes on (03)(04) as shown below. E E 03 Attach first side panel (03) to printer stand aligning the dowels (D) with the holes in the apron. Be sure the panel is centered before tightening the wood screw (F).
PAGE 3
STEP 4 Attach second side panel (03) the same as the first but place the lower shelf (04) in position by aligning the wooden dowels (E) with the holes in the side panel. E 04 E 03 Adult Assembly STEP 5 Apply presure to eliminate any gap between the lower shelf and the side panel and fix in place using wood screw (F). Adult Assembly F F F F F Congratulations ! Your Printer stand is now ready for use.