Owner Manual

Step Step 6
å
Fasten the LEFT END (B2) to the LEFT MOLDING (N2) on
the TOP (D2). Tighten two TWIST-LOCK FASTENERS.
å
Fasten the UPRIGHT (C3) to the TOP (D2). Tighten two
T
WIST-LOCK FASTENERS.
Page 11
B2
C3
D2
N2
How to use the TWIST-LOCK FASTENER
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
Edge with
TWIST-LOCK
FASTENER
Finished edge
Rounded edge
Dowel end
S
urface without
TWIST-LOCK
FASTENERS
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution