Owner Manual

Step Step 10
å
Carefully turn your unit over onto its front edges. Unfold the BACK (F2) and lay it over your unit.
å
A perforation in the BACK (F2) has been provided for access to the SAFETY STRAP. Punch out the perforation and push
the SAFETY STRAP through the hole.
å
Make equal margins along three edges of the BACK (F2). The BACK will overhang the BOTTOM (E2) slightly. Push on
opposite corners of your unit if needed to make it "square".
å
Fasten the BACK (F2) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (C3).
å
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
å
Push the FOOT (3E) into the hole in the BOTTOM (E2).
å
Fasten the TIE PLATES (3G) to the BASE (H) and PLINTHS (R2). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
P
age 15
E2
F2
H
3E
3G
R2
R2
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
1S
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(60 used for the BACK)
1N
These holes must line up
over the UPRIGHT (C3).
Cut-out (used for mirror)
The BACK will overhang
the BOTTOM slightly.
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.