Data Sheet
Table Of Contents
- 5.User Manual
- Revision History
- Table List
- About This Document
- Table of Contents
- Chapter 1. Overview
- Chapter 2. Interfaces Description
- 2.1. Interfaces parameter definitions
- 2.2. Pin description
- 2.3. Interfaces detail description
- 2.3.1. Power supply interface
- 2.3.2. RGMII interfaces
- 2.3.3. SPDIF interface
- 2.3.4. Audio interface
- 2.3.5. USB interface
- 2.3.6. PCIe interface
- 2.3.7. MIPI DSI interface
- 2.3.8. HDMI interface
- 2.3.9. JTAG interface
- 2.3.10. SDIO interface
- 2.3.11. BLSP interface
- 2.3.12. Power on interface
- 2.3.13. Reset interface
- 2.3.14. Boot configuration interface
- 2.3.15. Debug UART interface
- 2.3.16. PWM
- 2.3.17. Sleep clock
- 2.3.18. SPMI
- 2.3.19. Antenna interface
- Chapter 3. Electrical Characteristics
- Appendix 1. Notices
- Appendix 2. Trademarks
- 5.User Manual_ Warning
Integration instructions for host product manufacturers according to KDB 996369
D03 OEM
Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C&E has been investigated. It is applicable to the
modular.
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple
simultaneously transmitting condition or different operational conditions for a
stand-alone modular transmitter in a host, host manufacturer have to consult with module
manufacturer for the installation method in end system.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Yes, For details, see pages 5-16 of this document
2.6 RF exposure considerations
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance of 20cm from your body.
2.7 Antennas
This radio transmitter FCC ID: 2AOHHTURBOX-C405-D has been approved by
Federal Communications Commission to operate with the antenna types listed below,
with the maximum permissible gain indicated. Antenna types not included in this list that
have a gain greater than the maximum gain indicated for any type listed are strictly
prohibited for use with this device.
Antenna
Manufacturer
Antenna
Chain
Antenna
type
Input
impedance
(Ohm)
Maximum
antenna gain
BOSE
0 PCB 50
2.34 dBi/2.4-2.5GHz
2.33 dBi/5.15-5.85GHz
1 PCB 50
2.6 dBi/2.4-2.5GHz
3.11 dBi/5.15-5.85GHz
Molex
0 FPC 50
3.2 dBi/2.4-2.5GHz
4.25 dBi/5.15-5.85GHz
1 FPC 50
3.2 dBi/2.4-2.5GHz
4.25 dBi/5.15-5.85GHz
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains
FCC ID: 2AOHHTURBOX-C405-D”
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC
requirements for the transmitter when the module is installed in the host.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed
with all other applicable requirements for the system such as Part 15 B