Data Sheet

Statement

1. Conformity Assessment of the Radio Module to the RED

This radio module is for professional installation only. When installing this radio module

permanently into a host product to a create new radio equipment device; the manufacturer

responsible for placing the final radio product on the market in the EU must assess if the

combination of this radio module and the host product complies with the essential

requirements of the RE Directive 2014/53/EU.

2. Firmware version:

Test Antenna: PIFA Antenna and maximum gain 2dBi.

The final radio product will need to be fully assessed to Article 3.1a of the RED, for product safety

With regard to RF exposure for Article 3.1a of the RED, the manufacturer of the final radio product

will need to assess if the compliance assessment of the original radio equipment/module remains

relevant to the final radio product, or if further action is necessary.

This equipment should be installed and operated with minimum distance 20cm between the

radiator& your body.

If the final radio equipment is used at the same distance from a person or domesticated animal as

the radio module was assessed, (for example: >20cm), then the final radio product assessment

could conclude that the final radio product is compliant with the RF exposure requirements

without additional actions.

If the final radio equipment is used at a closer distance from a person or domesticated animal

than the radio module was assessed, then the final radio product assessment could not

automatically conclude that the final radio product is compliant with the RF exposure

requirements without additional actions; and further assessment is necessary.

The final radio product will need to be fully assessed to Article 3.1b of the RED, for EMC.

EMC testing of the radio module will have been performed on some sort of temporary host or test

jig; but now the module is in a new host product and the EMC performance of the final radio

product must be assessed. Most likely the host product will have its own EMC assessment for

other functions, which should be performed with the radio module installed; and inclusion of the

radio module into the host product will also require an assessment, such as to the relevant

applicable part of EN 301 489, on the final radio product.

In theory, radio transmitter or receiver measurements made as conducted measurements at a

radio module antenna port may be considered applicable to the radio performance of the final

radio product. However, in this example, the radio module does not have an antenna port. The

radio module has a pin which leads through a PCB trace to an antenna on the host product. If the

manufacturer of the final radio product wishes to use conducted power, conducted emissions or

receiver performance measurements from the radio module to show compliance of the final radio

product, then they will need to exactly follow the detailed instructions from the radio module

manufacturer; including input voltage, driver software, environmental conditions, antenna trace

layout design construction and material, circuit board layout design construction and material,

TurboX C610 SOM DATASHEET