User's Manual
Table Of Contents
- I.General
- II.Features
- 1. Adopting 470MHz wireless communication technolo
- 2. With battery low-voltage detection function, it
- 3. Use microprocessor to realize signal processing
- III.Technical specifications
- IV.Structure characteristics and working principle
- When the module input terminal receives the closin
- When the module receives the control signal from t
- When the module battery is low, the module sends a
- 3.Installation method
- V.Test
- Warning: Please make sure that the polarity of the
- 1. After the module is installed and tested every
- 2. Alarm test: After the networking is successful,
- 3. During the test, the unqualified modules are re
- VI. Use and operation
- VII. General failure and repair
- VIII. Notes
- 1. After the signal passes through the wall, the s
- 2. When installing the product, keep it away from
- 3. Install in a low-interference environment and f
JTY-GM-TC5401W 无线点型光电感烟火灾探测器安装使用说明书 Ver1.0 202010
辽宁•营口天成消防设备有限公司
8
times every 48s
above-mentioned multiple faults
one by one
After the device alarms, the
controller has no status prompt
The device is not connected to the
network
Restart the network operation
Device networking is
unsuccessful
Too far away from the controller or
interference sources nearby
Move the device near the controller,
reconnect to the network and remove
the source of interference
The fault yellow light keeps
flashing
The battery is low and the device is
not working properly
Change the battery
VIII. Notes
1. After the signal passes through the wall, the signal strength will be greatly attenuated, so try to reduce
the number of partition walls for wireless products.
2. When installing the product, keep it away from metal to reduce the shielding of metal objects to the
signal. For example, it cannot be installed in a metal box such as a fire hydrant box or outside of a metal
cabinet.
3. Install in a low-interference environment and far away from motors or large-scale electrical
equipment.
IX. Documents and warranty instructions
1. Packing documents: 1) Packing list: 1
2) Instructions: 1 copy
3) 10K resistance: 1
2. Warranty: Our company is responsible for the maintenance of this product. If you find any problems,
please contact our company's technical service department in time. Users are not allowed to disassemble
or repair by themselves, otherwise they will be responsible for the consequences.
3. The maintenance contact information is as follows: