Outdoor Omni Speaker Models GS3/ GS5/ GS5L/ GS7/ GS10 TIC Outdoor OmniSpeakers Feature Weatherproof Design True 360° Sound In-ground or surface mount Full range 100W or 200W speaker drivers (model dependent) 5”-8” co-axial drivers 1” aluminum tweeters Surge protected Revchem® Teflon® sealed 8 Ohm Impedance 70v optional for Commercial Installations 1m 14/2 Dbl. Insulated tail ABS Impact Resistant Formulated Enclosure Aesthetically, unobtrusive shrub green finish ©TIC Corporation U.S.A.
For your records… Manufacturers Name: TIC Model Number: Dealers Name: Purchase Date: TIC Corporation _____________ _____________ _____________ Manufacture Contact: Serial Number: Dealers Contact: Invoice/ Receipt Number: www.ticcorp.com (800) SPX-OMNI ________________ ________________ ________________ We recommend you keep your sales receipt and warranty card together with this owners guide for safe keeping and future reference.
Index… Introduction ………………….…………… 3 Component List …………………….……. 4 Pre-Installation …………………… …….. 4 Connection Cable ……… …………….... 5 Exterior Installation ……………………… 5/6 Maintenance ……………………………… 7 Customer Service ………………..……… 7 Warranty …………………………..……… 7 Trouble Shooting ……...…………….…... 9 Technical Specifications …………….….. 10 Thank You for purchasing another high quality audio product from TIC Corporation.
Component List… 1x (GS3, GS7L) 2x (GS5, GS5L, GS10) Outdoor Omni Speakers 1x (GS3, GS7L) 2x (GS5, GS5L, GS10) 1M 14/2 cable tail 30ft. cable 1x New product offer (enclosed with literature) 1x Instruction Manual 1x Warranty Card Pre-Installation… Need Professional Help? Please read this owners guide carefully before installation. Failure to follow these instructions fully or incorrect installation may damage your new TIC products and any third party equipment used in your new system installation.
Before you begin the installation of your new TIC outdoor product, please carefully select the locations of your new TIC products. In general; 1. Select a reasonably level surface for the installation of your new TIC outdoor speakers. For surface speakers this will prevent movement or excessive vibration during use. This will also ensure more uniform sound dispersion. 2. Ensure your new TIC outdoor speaker cables or power source if required, can easily reach your new speakers.
Before actually sinking the cable, run the cable from your unit to the power source or amplifier. Ensure your cable run avoids any obstacles such as sunken sprinkler pipes or piping and electrical cable to your house. Once the cable runs are where you like them, connect your speakers and power source to ensure correct operation before sinking the cable. Disconnect the cable wire at both ends and continue. An Important note on Polarity! Pleasure proper polarity when connecting your new TIC outdoor speakers.
Once connected properly, fill in all trenches, sit back and enjoy! Disclaimer; TIC Corporation will in no way be held responsible for the improper or unsecured installation of this product. Any and all damage arising from the installation or use of this product is the purchaser and final installer’s sole responsibility. Maintenance… Occasional maintenance of your TIC products cannot hurt and may help greatly.
Installation Notes… 1. The TIC GS10 Omni Speaker model requires no in-ground speaker or cable installation. This omni speaker unit is often used portably and is only permanently installed to the customer’s specification. 2. The GS5L & GS7 models also provide a gentle 360° light using a low voltage 25W/ 12v, lamp. This also requires you to connect the low voltage lighting transformer.
Trouble Shooting… Problem Please Check No Sound Check the speakers are connected to the cable correctly. Check the speaker cable is connected to the receiver amplifier correctly. Check the receiver amplifier is powered “on” at the mains, is not on “mute”, has no headphones attached and that the Channels used for the exterior speakers (usually A or B) is in operation. Refer to the owners guide that came with your receiver amplifier.
General Specifications Outdoor Omni Speakers GS3, GS5, GS5L, GS7, GS10 Models Speaker Drivers Woofer(s) Tweeter Cabinetry Grill Frequency Response 5” or 8” full range Co-Axial Drivers Injection molded PP cone with Butyl rubber surround 1" aluminum Impact resistant ABS Anodized “sound assist” 5”: 67Hz – 19kHz 8”: 36Hz – 19kHz Sensitivity @1W/1m 5”: 86db ± 3db 8”: 89db Continuous/ Peak 5”: 50 / 100W 8”: 100 / 200W *Inches GS3 GS5 GS5L GS7L GS10 Unit Size 12.5x12.5x12.5 8.8x8x8 10x8x8 13.5x12.