Faucets by R GF65-S Stainless Steel Soap / Lotion Dispenser 1
Contents Prior to Installation, Maintenace ................................ 3 Specifications ..................................................................... 4 Parts List ............................................................................... 5 Installation ........................................................................... 6 Customer Support ticorsinks.com support@ticorsinks.
Prior to Installation: • • Pre-drilled hole size requirement: 13/8” minimum to 11/2” maximum. Max countertop thickness: 2” • • Requisito de tamaño de orificio pre-perforado: 13/8 “mínimo a 11/2” máximo. Grosor máximo de la encimera: 2 “ Tools You Will Need: #2 Phillips Screwdriver Care and Maintenance • • • To clean, rinse with water and dry with a microfiber cloth. Do not use soaps, acids, abrasives, or chemical cleaners.
Dispenser Specifications Geyser 3¾” GF65-S Stainless Steel Soap Dispenser 2 ½” Height: 11¾” Height Above Counter: 2½” Height Below Counter: 9¼” Threading Length: 2¼” Spout Reach: 3¾” Bottle Capacity: 8oz 11¾” 9 ¼” 4
Parts List 1. Pump and Straw bomba y paja 2 1 2. Shank Caña 7 3 3. Deck Ring Anillo de cubierta 4. Rubber Gasket Junta de goma 4 5. Metal Washer Arandela de metal 5 6. Mounting Ring Anillo de montaje 6 7.
Dispenser Installation Step 1 Slide the deck plate (3) onto the shank (2) from below. Place the shank into the hole in countertop or sink. Countertop Deslice la placa de cubierta (3) sobre el vástago (2) desde abajo. Coloque la caña en el orificio de la encimera o el fregadero. Step 2 From beneath the countertop, slide rubber washer (4) onto threaded mounting pipe, followed by the metal washer (5).
Dispenser Installation continued Step 3 Use a Phillips screwdriver to fully tighten the screws on either side of the mounting ring (6). 1⁄4” Gap Utilice un destornillador Phillips para apretar completamente los tornillos a ambos lados del anillo de montaje (6). Step 4 Screw the reservoir bottle (7) into the shank (2). Pour soap or lotion into the mouth of the shank until reservoir bottle is full. Seat the pump (1) in the shank. Atornille la botella del depósito (7) en el vástago (2).
