Installation Guide

4
laminate type countertops, waterproof all
unprotected areas of wood.
8. Clean the top of the sink rim and the bottom
of the countertop, making sure the surface is
free from debris.
9. Apply a generous bead of sealant around the
sink rim where the sink rim will contact the
countertop.
10. Position the countertop over the sink,
making sure the sealant provides a complete
seal between the sink rim and the bottom of
the countertop.
CARE AND CLEANING
11. Immediately wipe away any excess sealant
with a damp cloth. Fill any voids between the
rim and the countertop if needed.
12. Allow the sealant to cure for at least 30
minutes before proceeding.
13. Install the faucet to the sink and countertop
according to the manufacturer’s instructions.
14. Connect and tighten the trap to the strainer,
and complete the water supply connections
to the faucet according to the instructions
packed with the faucet.
15. Run water into the sink and check for leaks.
16. Clean up with a non-abrasive cleaner.
• Be careful not to leave staining materials in contact with the surface for extended periods of
time.
• The ideal cleaning technique is to rinse thoroughly and blot dry any water from the surface
after each use.
• Use a mild detergent such as liquid dishwashing soap and warm water for cleaning. Do not
use abrasive cleaners that may scratch or dull the surface.
• Carefully read the cleaner product label to ensure the cleaner is safe for use on the
material.
• Always test your cleaning solution on an inconspicuous area before applying to the entire
surface. Cleaners containing chloride are not recommended.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner.
Rinse and dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or
scouring pad to clean surfaces.