Installation Guide

2
PREPARATION
NOTE: You may use the provided brackets
(Four) to tighten the sink flange to the countertop
on the back side of the sink. Check with the
countertop manufacturer for proper use of
fastener. If you choose this option, you do not
need to install the back support.
1. Install the water supplies and drain piping
according to the roughing-in information.
2. Determine the faucet you will install. Make
sure there is enough room between the
backsplash or wall and back edge of the sink for
your faucet.
3. If you have not already done so, determine
the distance the apron will extend beyond the
face of the cabinet. The apron should extend no
less than 1-1/2” (1.3 cm) and no more than 2-
3/4” (7 cm).
4. Construct a wood frame to fit inside the
cabinet opening. The cabinet opening should be
33” (83.8 cm) wide.
5. The side supports should be 10” (25.4 cm)
long unless the back support is thicker than 1”
(2.5 cm). If the back support is thicker than 1”
(2.5 cm), determine the length of the side
supports by measuring from the inside edge of
the back support to the inside edge of the apron.
6. The back edge of the support frame should be
located 17-3/8” (44.1 cm) from the front of the
sink. Do not measure from the front of the
cabinet.