Installation Guide

3
INSTALL THE SINK
NOTE: Use shims to level the sink if needed.
1. Verify that the sink will fit in the cabinet
opening. If necessary, adjust the opening by
sanding the opening or adding wood filler strips.
2. Install the strainer or garbage disposal to
the sink according to the manufacturer’s
instructions.
3. Apply a 1” (2.5 cm) spot of sealant at each
corner of the frame where it will contact the sink.
NOTE: If using shims additional sealant will be
needed.
4. Carefully position the sink within the
frame, making sure to center the sink in the
cabinet.
5. Verify that the sink is level. The top of the
sink should be flush with the top of the cabinet to
allow proper countertop installation. Adjust or
shim between the sink and support if needed.
6. Carefully measure the countertop to
determine the exact location of the cutout.
7. Carefully mark the cutout location on the
countertop.
COUNTERTOP AND FAUCET INSTALLATION
NOTE: The dimensions of your faucet may differ
from those shown. Check the roughing-in
dimensions of your faucet against those given.
CAUTION: Risk of product damage. Do not cut,
drill, or sand the countertop while positioned
over the fixture.
1. Measure 1-1/2” (3.8 cm) from the back edge
of the sink cutout and mark at multiple spots.
Draw a straight line through the marks.
2. Determine the faucet mounting location. Mark
the center of the location on the first line. This
is the centerline of the faucet.
3. Mark the locations of the handles and the
faucet.
4. Measure the distance “Y” and verify that there
is adequate clearance between the faucet
handles and the backsplash or finished wall to
ensure proper faucet operation.
5. Cut out the sink opening by carefully following
the pencil line.
6. Drill the faucet holes.
7. Sand the edge of the cutout to smooth the
surface and remove all saw marks. For