Technical Specifications

(404) 344-0000 • Fax (404) 349-0401 • www.tranzsporter.com

Assembly Instructions TP250/400 Secondary Handle Kit #48468 (Purchased Separately)

Allows use of a left side handle to engage the motor and carriage. It is highly recommended when using with the Solar/Plywood Saddle

Carriage. Can be used for both TP250 & TP400 models.

Parts included with the Secondary Handle Kit:

1) Handle. 2) Pivot/Brake Weldmont

3) 2 Mounting Plates 4) 4 Screws

Step 1

Lay the base section ﬂat on a hard surface. Locate the mounting slot

and holes on the bottom portion of the base section.

Step 2

With one hand, hold the pivot/brake weldment just

above the lower base section. Slide the mounting

plates over the pivot/brake rod. Make sure the raised

hole side of the mounting plates goes on the inside.

Step 3

Holding the pivot/brake weldment/mounting plates with one

hand; slide the mounting plates into the slots on both sides

of the base section. The plates should slide into place with the

notch ﬁtting thru the base section.

Using the two holes provided; insert two screws per side.

Tighten screws using a screw driver or wrench.

Attach secondary handle on either side of the hoist.

Mounting Holes

Mounting Plate

“Notch”

Mounting Slot