Technical Specifications

Tie Down Engineering • 255 Villanova Dr. SW • Atlanta, Georgia 30336

Feed end cable

through pully

Unwind cable

from the back

Attach cable to

the back of the

carriage (cross bar

)

Step 10

Attach cable to the carriage assembly, pass bolt through

lock washer, washer and cable end/eye. Tighten bolt as

shown right.

Bolt

Cable Eye/End

Lock Washer

Washer

Carriage Cross Bar

Assembly Instructions for the TP250 Hoist

Instructions for the TP400 Hoist skip to page 11

You have completed the assembly of the TP250 Hoist

Skip to page 9 for Operation and Placement Instructions.

Step 8

From the back side of the hoist, remove the end of the cable from

the drum (shown right). It helps to attach the brake handle, use

the brake handle back releases the brake drum. The cable will

then easily un-spool. Staying on the outside (back) of the base

section and track section, take the cable to the top of the last track

section where the top cap pulley is attached.

Step 9

Feed the cable end through the pulley as shown above , and

down the front side of the track section to the back of

the carriage assembly.