Technical Specifications

[phone] • Fax [phone] • www.tranzsporter.com
4
Step 5
Lay one track section on a flat floor with the “front” side up. This is
determined by the space between the track cross bar and the track
section edge as shown above.
Step 6
Attach splice plates to the bottom section of the track. Splice plates are mounted on the outside track section. Slide the top section track
into the groves on the inside track section, attach with 2 nuts and bolts per side (Pictures 4 & 5).
NOTE: DO NOT SUBSTITUTE NUTS AND BOLTS
Use 3/8”x 3/4” bolts and 3/8” nut keeps (lockwasher and nut combined).
Front
Back
Picture 5
Picture 4
Step 7
Reattach the top cap to the end of the last section of track section you intend to use. Assemble with two 3/8”x 3/4” hex head bolts with lock nuts
provided. Make sure that the top cap end slides into the outside of the track section (picture 6).
Picture 6
Assembly Instructions for the TP250 Hoist
Instructions for the TP400 Hoist skip to page 11