User Manual

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com (404) 344-0000 Fax (404) 349-0401

022213,A1308

Mounting Base Stand

GalvX #86911 / Galvanized #86929

MAKE YOUR DOCK A DESTINATION

Instruction Sheet #08190

Tools Required:

Screw Driver

GalvX Dual Coat Finish - #86911 Parts List

# Part # Qty Description

1 86911-1A 1 Mounting Base

2 10841 4 3/8" Washer

(For use with Treasure Garden Umbrella Stand)

3 12159 4 8mm x 1.25" Nyloc Nut

(For use with Treasure Garden Umbrella Stand)

4 10660 2 Knob(s)

Hot Dipped Galvanized Finish - #86929 Parts List

# Part # Qty Description

1 86929-1A 1 Mounting Base

2 10841 4 3/8" Washer

(For use with Treasure Garden Umbrella Stand)

3 12159 4 8mm x 1.25" Nyloc Nut

(For use with Treasure Garden Umbrella Stand)

4 10660 2 Knob(s)

PAGE 1
Mounting Base Stand MAKE YOUR DOCK A DESTINATION GalvX #86911 / Galvanized #86929 2 3 4 Tools Required: Screw Driver 1 Hot Dipped Galvanized Finish - #86929 Parts List # Part # Qty Description 1 86929-1A 1 Mounting Base 2 10841 4 3/8" Washer (For use with Treasure Garden Umbrella Stand) 3 12159 4 8mm x 1.25" Nyloc Nut (For use with Treasure Garden Umbrella Stand) 3 12159 4 (For use with Treasure Garden Umbrella Stand) 4 10660 2 Knob(s) 8mm x 1.
PAGE 2
Mounting Base Stand GalvX #86911 / Galvanized #86929 1 Eye bolts secure the receiver to the base. Once the holes are aliened hand tighten all eye bolts. Assembly Instructions: 1 Slide base of support tube into receiver until threaded holes align with holes in receiver. 2 Slide eye bolts through receiver side holes and screw into theaded holes in accessory base. Hand tighten all eye bolts and then use screw driver shaft to tighten one half turn.