Manual

6
9. Assemble Bow Stop
Attach 4 inch spool rollers to the bow stop using two hex
head bolts, 5" x 1/2", two at steel washers and two 1/2"
nyloc nuts. The washers are used on top of the rollers.
(Picture 12)
Slide the bow stop over the upright winch mount tube, rub-
ber rollers in the "up" position. Using the holes in the bow
stop plate next to the winch mount tube,place a 4 inch x
3/8" bolt and nyloc nut. Tighten bolt so that the bow stop is
about 12 inches below the top of the tube. You will adjust
this later to t your watercraft.
10. Attach Winch & Winch Mount to
Winch Mount Tube
Attach winch mount to winch using three - 3/8" x 1" hex bolts
and nyloc nuts (picture 13). Attach winch mount & winch, to
tube as shown in picture 14, using two - 3/8" x 4" hex head bolts.
(Picture 14)
Parts required for this step.
# Stk. # Description Qty.
8 26612 Bow Stop 1
23 17052 Spool Rollers, 4" 2
30 10938 1/2" x 5-1/2" 2
Hex Head Bolt
33 10645 1/2" Nyloc Nut 2
37 BBW500 1/2" Flat Washers 2
28 BBB3750400 3/8" x 4" Hex Head Bolt 1
34 BBN375NL 3/8" Nyloc Nut 1
Parts required for this step
13 17150 Winch 1
28 BBB3750400 3/8" x 4" Hex Head Bolt 2
34 BBN375NL 3/8" Nyloc Nut 2
7 26611 Winch Mount 1
27 BBB3750100 3/8" x 1" Hex Head Bolt 3
34 BBN375NL 3/8" Nyloc Nut 3
30 & 37
33
23
13
Picture 13
27 & 34
7
Picture 12
Picture 14
9
8
Requires part #'s ` 10985 qty. 1
10645 qty 2
44540 qty 1
See "NOTE" on Page 8
for this step.