Use and Care Manual

Instructions:
1. Turn off water supply. Press red pressure-relief button (if
present).
2. Unscrew housing. Remove large o-ring, wipe clean and set
aside.
3. Discard used filter cartridge. Wash housing with dish soap
and warm water using a nonabrasive sponge or cloth. Rinse
thoroughly. Fill 1/3 with water. Add about 1 tablespoon of
bleach and scrub to disinfect. Rinse thoroughly.
4. Fill 1/3 with water. Add about 1 tablespoon of bleach and
scrub to disinfect. Rinse thoroughly
5. Lubricate o-ring with clean silicone grease. Change o-ring if
any damage cuts or degradation are present. Insert o-ring in
groove
6. NOTE: This step is important to ensure a proper housing seal.
Make certain the o-ring is seated level in the groove
7. Insert new filter cartridge
8. Screw housing onto the cap and hand-tighten. Do not over
tighten. Make sure cap standpipe slips into cartridge
9. Turn on water supply. Press pressure-relief button (if
present). Check for leaks before leaving installation