Use and Care Manual

14
13
Familiarize with Button Configuration:
3. Power and Program the Valve
Attach the Transformer cable to the valve and plug in the transformer to the 110V Power outlet. you will notice the two screens on right will alternate.
6(77,1*6 83
'2:16(/(&7
TIME
08:27 AM
6(77,1*6 83
'2:16(/(&7
REMAIN
DAYS 03
1. Press MENU key
to advance to TIME OF DAY. TIME OF DAY will flash.
6(77,1*6 83
'2:16(/(&7
TIME
08:27 AM
2. Press the UP or DOWN key
to adjust the TIME OF DAY. Press & hold the UP or DOWN key
to quickly advance the hour and minutes. When desired time
is displayed press SET
to advance to the DAYS setting. DAYSwill flash.
6(77,1*6 83
'2:16(/(&7
DAYS
03
3. Press the UP or DOWN key to adjust the DAYS (Min 1.Max 199). When desired hardness is displayed press SET
TIME
08:27 AM
KEYPAD
CALENDAR
CLOCK
TIME
10:15 AM
REMAIN
DAYS 03
TIME
10:15 AM
REMAIN
GAL 1075
TIME
10:15 AM
REMAIN
GAL 1075
TIME
10:15 AM
REMAIN
DAYS 03
REMAIN
GAL 1075
METER
IMMEDIATE
METER
DELAYED
METER
OVERRIDE
1
1. Connect the transformer
to the valve. Plug the
12-volt transformer into
a 120 VAC 60 Hz outlet.
2. Open the brine tank /
cabinet salt lid and
add water until there is
approximately 3” (75 mm)
of water in the tank. Do not
add salt to the brine tank at
this time.
STARTUP INSTRUCTIONS
This function is to accept the values if changed and advance to the next page in
the menu.
These buttons are used to increase or decrease the value of the settings while in
the programming mode.
This function is to enter the basic set up information required at the time of
installation.
Key Pad Configuration: