Use and Care Manual

General Information
5
the installation of your UV disinfection system. These water quality parameters can be tested by your local dealer, or by most
private analytical laboratories. Proper pre-treatment is essential for the UV disinfection system to operate as intended.
Section 2 General Information
Figure 1 System Components
Item Description Part Number UV Systems
1 Temperature management valve (optional) 440179 Optional
2 Flow restrictor (Only for certified models)
440315-R VH200-V
440316-R VH410-V, VH410M-V
3 Lamp connector base 270276-R Used on all systems
4 O-ring 410867 Used on all systems
5
Open-ended, GE 214 fused aquartz sleeve
with fire polished ends
QS-001 VH200, VH200-V
QSO-410 VH410, VH410M, VH410-V, VH410M-V
QSO-600 VP600, VP600M
QSO-950 VP950, VP950M
6
Hard glass, coated Sterilume
®
-HO UV lamps
for long, consistent life (9000 hours)
S200RL-HO VH200, VH200-V
S410RL-HO VH410, VH410M, VH410-V, VH410M-V
S600RL-HO VP600, VP600M
S950RL-HO VP950, VP950M
7 Retaining Nut RN-001 Used on all systems
8
Controller (for 100-240V/50-60Hz models
only)
BA-ICE-CL VH200, VH410, VH200-V, VH410-V
BA-ICE-C VP600, VP950
BA-ICE-CM VH410M, VH410M-V, VP600M, VP950M
9
IEC replacement power cords for controller
(sold separately)
602636
VH200, VH410, VH410M, VH200-V, VH410-V, VH410M-V, VP600,
VP600M, VP950, VP950M (N. America)
602637
VH200/2, VH410/2, VH410M/2, VH200-V/2, VH410-V/2, VH410M-V/2,
VP600/2, VP600M/2, VP950/2, VP950M/2 (EU CEE)
260012
VH200/2B, VH410/2B, VH410M/2B, VH200-V/2B, VH410-V/2B, VH410M-V/
2B, VP600/2B, VP600M/2B, VP950/2B, VP950M/2B (UK)
260013
VH200/2A, VH410/2A, VH410M/2A, VH200-V/2A, VH410-V/2A, VH410M-V/
2A, VP600/2A, VP600M/2A, VP950/2A, VP950M/2A (Australia, NZ)
260019 NO CONNECTOR, 3-WIRE, BARE LEADS
10 Mounting Brackets/Clamp Assembly 410076 Used on all systems
11 UV Sensor 254NM-C1 VH410M, VH410M-V, VP600M, VP950M
12 Spring SP008 Used on all systems
13 Retaining nut with the plug RN-001/1 Used on all systems
2
8
9
10
11
12
13
1
3
4
5
6
7