Instructions / Assembly

14
5/8" hole in brine
well cap
Res-up feeder
1/4” Holes
Res-up Feeder Bottle (Chemical sold Separately)
The 12 cc feeder (Part # 33010) is for conditioners up to 64,000 grains (2 ft3 of
resin).
The 30 cc feeder (Part # 33018) is for larger conditioners over 64,000 grains.
Pro-Res Care Chemicals
Item #45147 Pro-ResCare - Gallon
Item #45148 Pro-ResCare - Quart
1. Install the grid and brine well inside the tank. 3. Mark the location of the holder and drill.2. Measure 2 inches from the top of the tank beside
the oblong molding.
Install Resup Feeder - Round Brine Tank
Care of Your Softener
To retain the attractive appearance of your new water softener, clean occasionally with a mild soap solution. Do not use abrasive cleaners, ammonia or solvents. Never subject
your softener to freezing or to temperatures above 43°C (110°F).
Servicing Components
The injector assembly should be cleaned or replaced every year depending on the inlet water quality and water usage.
The seals and spacer cartridge should be inspected/cleaned or replaced every year depending on the inlet water quality and water usage.
Please refer to the servicing section of this manual for step by step procedure.
Not following the above will void all warranty on the control valve.
Resin Cleaner
An approved resin cleaner MUST be used on a regular basis if your water supply contains iron. The amount of resin cleaner and frequency of use is determined by the quantity of
iron in your water (consult your local representative or follow thedirections on the resin cleaner package).
RES-UP
®
FEEDER INSTALLATION
INSTRUCTIONS (OPTIONAL)
Res-Up Feeders attach to your brine tank and automatically dispense the Res-Up cleaner into the brine solution where
it cleans the resin during the regeneration cycle.
The feeder hooks onto the tube inside your brine tank and you just pour some chemical in it and your water softener
should last signicanly longer. A res-up feeder is essential if your raw water contains measurable amounts of iron.