No.
Product Description The TIF No. IR-1 uses infrared optics to create a refrigerant leak detector that combines sensitivity, speed, battery life, portability, and ease of use. This unit detects leaks as small as 0.15 oz/year, and meets both SAE J1627 and J2791 standards. The IR-1 comes with a wall charger and a car charger for its compact lithium-ion battery—which can power the leak detector for up to eight hours of continuous operation before needing to recharge.
Safety Precautions Warning: To prevent personal injury and/or equipment damage, l Read, understand, and follow all warnings stated in the Lithium Battery Care section of this manual. l DO NOT charge the battery with any charger other than the chargers supplied with the unit. l DO NOT use the IR-1 without a clean filter correctly installed in the tip. l DO NOT draw moisture in through the probe. Lithium Battery Care The IR-1 operates on a lithium-ion type NP-120 battery.
Charging the Lithium Battery Two types of chargers are supplied with the IR-1 leak detector. The AC charger plugs into a wall outlet (100-240 VAC, 50/60 Hz); the car charger plugs into a vehicle cigarette lighter DC plug. 1. Before using the unit the first time: Fully charge the battery. The unit was packaged and shipped from the factory with the battery only partially charged. 2. When the battery is low: The LOW-BATT LED will illuminate in red. 3.
Mute Button Press the MUTE button to toggle the audio portion of the IR-1 on or off. Peak Button The PEAK function stores the highest change in refrigerant concentration achieved while continuing to detect leaks. Press the PEAK button to toggle this function on and off. The PEAK LED illuminates when this function is turned on. Turning the PEAK function off clears the peak information.
D. Move the tip back to, and past, the first leak spot noted. When the IR-1 indicates a second change, note that spot on the line. The leak will be near the midpoint of the two noted change spots. NOTE: If the tip is held at a detected leak for more than five seconds, the IR-1 will not detect a change. E. The IR-1 is sensitive and can take up to 30 seconds to clear after detecting a small amount of contaminate. Typically, it will clear in 2 to 15 seconds.
Accessories and Replacement Parts Optional Accessories Order No. Extension Probe (9 inch).......... TIFIR-4 Rigid Extension Probe.............. TIFIR-5 Replacement Parts Order No. 100-240 VAC Charger.............. TIFIR-6 12 VDC Charger....................... TIFIR-7 Filters (5) and O-rings (3)......... TIFIR-8 Lithium-ion Battery................... TIFIR-9 Filter Replacement A filter, located in the tip of the wand, blocks moisture and other contaminants from the sensor.
Warranty This product has been produced to provide unlimited service. Should it become inoperable after the user has performed the recommended maintenance, a no-charge repair or replacement will be made to the original purchaser. This applies to all repairable units that have not been damaged or tampered with. The claim must be made within ONE YEAR of the date of purchase. Garantía Este producto se produjo para proporcionar servicio ilimitado.