User Guide

Assembly Section 2-6
ASSEMBLY
Align the valve mounting plate with the drilled holes. Mark the center of one of the
holes above and in line with the slotted holes in the valve plate. Do not use any holes
that will be used to mount the valve on the plate.
Mount the lift valve with the supplied hardware. Refer the parts section for the
details.
LIFT VALVE MOUNT
Drill a Ø9/16” hole in the fender frame tube of the tractor 3/4” back of the existing
hole (away from cab). Install the right valve mounting bracket to the inside of the right
fender frame tube as shown below and attach it with hardware listed in the parts
section of this manual. Repeat these steps for the left valve mounting bracket.