- Tiger Corporation Lawn Mower User Manual

ASSEMBLY
Assembly Section 2-14
REAR STOW LYNX HOSE ROUTING
WARNING NOTE: The sudden release of hydraulic pressure could cause the sudden
movement of very heavy parts. Anyone in the way of these parts could be severely hurt
or killed. DO NOT ALLOW these hydraulic hoses to BREAK or BURST in order to
prevent hydraulic failure Make sure the hoses do not pinch or stretch as boom moves.
Measure TWICE, check TWICE then proceed with caution.
Route the hoses through the space between the swivel and the boom mounting
bracket. Connect the hoses to the preformed tubes and move the boom arm to a few feet
from full forward. Assemble the swivel clamp and place the return hose for the motor on
top and the pressure line on the bottom. Place the ¼” hoses in the “C” clamp and add it
to the bottom screw of the swivel clamp. Next, make sure there is enough slack for all
hoses to pivot at the joint where the main boom arm bends in the swivel, as shown in the
next image, and tighten the hoses in the clamp.