Use and Care Manual

1515

After Finishing Using the Heater

Unplug

Beeping

sound

Unplug

Remove the lid

While pressing down on the attach / remove lever for the

lid, open and remove the lid by pulling the lid toward the

spout.

Discard remaining hot water

(Refer to

p. 8

)

•

Move the unit to the kitchen sink and

then discard water slowly. Caution

for hot water may splash during this

operation.

•

Watch out for hot water dripping from

the spout immediately after discarding

the hot water.

•

Be sure to clean the inner container

and mesh filter. (Refer to p. 16)

Caution

Attach the lid

While pressing down on the attach/remove lever for the

lid, insert the hook-on part of the lid.

•

Do not leave hot water remaining

inside the container, this is to avoid

discoloration of the inside container or

foul odors from forming.

•

Do not turn the spout downward with

the lid on, or discard hot water from the

hinge area, this is to avoid scalds from

splashing hot water or malfunction.

•

Pay extra attention when discarding the

remaining hot water, as the mesh filter

may fall if it is not properly attached.

Caution

PAGE 1
7 1 After Finishing Using the Heater 4 Unplug Attach the lid While pressing down on the attach/remove lever for the lid, insert the hook-on part of the lid. Beeping sound Unplug Unplug 2 Remove the lid While pressing down on the attach / remove lever for the lid, open and remove the lid by pulling the lid toward the spout. Caution 3 Discard remaining hot water (Refer to p. 8) Caution 15 • Move the unit to the kitchen sink and then discard water slowly.
PAGE 2
8 Cleaning ■Unplug, discard remaining hot water, and wait until the unit cools down before cleaning can be started. ■Only use clean soft materials such as cloth, sponge, or paper towel. Parts Cleaning English Any other servicing should be performed by an authorized service representative. ❶ Simply rinse thoroughly with water and wipe the inside liner with a clean sponge or paper towel.
PAGE 3
8 Cleaning How to remove mineral deposit with citric acid Caution When washing the inner container with citric acid, be sure to follow the directions below, this is to avoid hot water spills or scalds. • Do not fill with hot water. Be sure to wash with cold water. • Do not fill with water above the full water level. • Do not open the lid during cleaning cycle. • Be aware of hot steam during cleaning cycle. ※ Other functions are not available during cleaning cycle.